Current position: Product list Product details
< >

0.9 inch 128×32 4 Wire Serial OLED Display

SCE091003-V01 is a OLED Display with COG Type, 128×32 Resolution, SSD1306BZ IC, 4 wire serial interface, 15PIN

  • Type: OLED
  • Mode: -
  • Product No: SCE091003-V01
  • Size: 0.91''
  • Resolution: 128*32
  • Outline Dimension: 30.0*11.50*1.227
  • Active Area: 22.384*5.584
  • Interface: 4-wire SPI
  • IC: SSD1306BZ
  • Brightness: -
  • Touch Screen: No
  • View Direction: -
  • Pin No: 15
  • Shape: Rectangle
Inquiry Now

Introduction:

General Specification

 

ITEMSPECIFICATIONS UNIT
  MODULE SIZE30.0(W)x11.5(H)x1.227(D)mm
  VIEWING AREA24.384 (W) x 7.584(H)mm
  ACTIVE AREA22.384 (W) x5.584(H)mm
  DOT SIZE0.159(W) x0.159(H)mm
  DOT PITCH0.175(W) x0.175 (H)mm
  ASSY.TYPECOG
  WEIGHTTBD

 Interface Definition

 

PIN NO.SYMBOLTYPEFUNCTION DESCRIPTIONS
1C2P
C1P/C1N-Pin for charge pump capacitor.
C2P/C2N-Pin for charge pump capacitor.
Connect to each other with a capacitor. They must be floated when the
Charge pump not use.
2C2N
3C1PI
4C1N



Power supply for charge pump regulator circuit.
5VBATPPower supply for charge pump regulator circuit.
It must be connected to external source when charge pump is used. It must be float when charge pump is not used.
6VSSPGround pin. It must be connected to external ground.
7VDDPPower pin for logic circuit. It must be connected to external source.
8CS#IChip Select input pin. Active “L”
9RES#IHardware reset input pin. Active “L”.
10DC#IThis is Data/Command control pin.
When the pin is pulled HIGH, the data at D[7:0]  is data. When the pin is pulled LOW, the data at D[7:0] is command.
11SCLKI4 wire serial interface clock wire
12SDINI4 wire serial interface data wire
13IREFICurrent reference for brightness adjustment.
This is segment output current reference pin. A resistor should be connected between this pin and VSS .Set the current at 12.5 uA maximum.
14VCOMHOCOM signal deselected voltage level.
A capacitor should be connected between this pin and VSS.
15VCCPPower supply for OLED driving voltage. A capacitor should be connected between this pin and VSS, when charge pump is used.
It must be connected to external source when charge pump is not used.


Technical support

Previous Product Previous Product : 0.91'' 128×32 I2C OLED Displays

Next Product : 0.96 Inch 128×64 Mono OLED Displays Next page